rubbing拓印课件.pptxVIP

RUBBING Maple Violet 拓印 tàyìn A rubbing is a reproduction of the texture of a surface created by placing a piece of paper or similar material over the subject and then rubbing the paper with something to deposit marks , most commonly charcoal or pencil ,but also various forms of blotted and rolled ink , chalk, wax ,and many other substances. 拓印是一个复制一个表面放置一张纸或类似材料的主题然后搓纸的东西存标志创建的纹理，最常用的木炭或铅笔，而且各种形式的遮蔽和滚墨，粉笔，蜡，和许多其他物质 For all its simplicity ,technique can be used to produce blur-free images of minuscule elevations .And depressions on areas of any size in a way that can hardly be matched by even the most elaborate , state-of-the-art methods. 尽管简单，技术可以用于产生微小的升高无模糊的图像。在这样一种方式是很难被应用，即使是最精心匹配领域的任何大小，用最先进的方法。 Rubbing tool 白芨水 Baijishui 刷子brush 拓包dabber 墨汁 墨汁Chinese ink 宣纸 宣纸rice paper HOW TO MAKE RUBBING Preparation of the first stage tool 1, Rubbing must first clean the dust in the monument 2, prepared paper must be larger than the stele, up, down, left and right slightly about 2 ~ 3 cm. 3, water hyacinth bletilla on the same day or the day before to prepare early, do not store, to avoid the loss of viscosity. 4, the extension package two, an ink, a uniform ink. Can be used interchangeably.“ 5, brushes, basin, ink, 第一阶段 准备工具1、拓碑前必须先清洁碑上的灰尘2、纸的准备必须比碑大，上下左右稍大约二~三公分。3、白芨水必须于当天或前一天准备，切勿提早储存，以免失去黏性。4、拓包二个，一个沾墨汁，一个均匀墨色。〈可交替使用〉5、刷子、盆子、墨汁、喷枪 Second stage paper In 1, the first monument brush a layer of water hyacinth bletilla, must be coated evenly. 2, paper by the fourth corner using a soft bristle brush by and by in and around the brush from the inside out flat and drive out the air the paper and the monument seal 第二阶段 上纸1、先在碑上刷一层白芨水，必须涂均匀。 2、上纸由上而下对其四角之后用软毛刷由上而下由中而左右由内而外刷平，同时赶走空气使纸与碑面密合  Third stage beat On the 1, with the brush, so that the text a uniform, but not too beat vigorously, so as to avoid the extension of paper rupture. 2, beating power needs to be uniform, not heavy and light, about 0.5 cm of each word recessed can, the first longitudinal or first