本菲卡~佩德罗60kV线路说明书.docVIP

General 总则 Design basis 设计基础 Codes and standards 标准 a Design criteria of overhead transmission lines（IEC60826） 架空电缆设计标准（IEC60826） b The transmission line design should observe other relative design standard. 传输线路设计应该参考其他相关的设计标准 Scope of construction work of 60kV overhead transmission line. 60kv架空电缆施工工程范围 60kV Transmission Line for S/S Benfica to S.Pedro the material for 60kV transmission line is listed in Table 1. 该工程所需材料如表1 Table 1 Total Length 总长度 [km] 6 Conductor Type 导线类型 LGJ-185/25 Quantity of Straight Pole（1m） 4 Quantity of Straight Pole（1m） Quantity of Straight Pole（m） Quantity of Angle Pole（～0°） Quantity of Angle Pole（～30°） Quantity of Angle Pole（～0°） Quantity of conductor [km] 导线长度 2.5 Line Route 线路路线 The 60kV transmission line is to be built from S/S Benfica power station to S.Pedro substation. 60kv架空电缆设计从S/S Benfica发电厂开始到S.Pedro变电站 Meteorological Conditions气象条件 This project is situated in the southern hemisphere, which is of tropical climate and has no ice accretion. The topmost altitude for the line route is 1900m. The maximum wind speed 10min at the level of 10m above the ground is 30m/s. 该工程位于南半球，是热带气候，无冰雪影响。线路海拔最高处是1900m The specific meteorological conditions as design criteria for this project are listed in Table 2.本项目设计依据的气象条件如下表2 Working condition 工作条件 Temperature（C°） Wind Speed（m/s） Max .Temperature 最高温度 38 - Min. Temperature 最低温度 10 - Everyday Temperature 日常气温 20 - Max wind speed 最大风速 20 30 Accident condition 故障工况 10 - Installation condition 安装工况 15 10 4 Conductor The LGJ-185/25 Aluminum Conductor Steel Reinforced shall be used. 本项目使用LGJ-185/25 钢芯铝线 In this project, one ground wire is used. The GJ-35 stranded steel wire is the type of ground wire.在本项目中，使用一根接地线，该接地线为GJ-35类型。 Conductor Type 导线类型 LGJ-185/25 Diameter [mm] 直径 18.9 Cross section [mm2] 截面积 Aluminium 铝 187.04 Steel 钢 24.25 Total总 211.29 Mass [kg /m] 0.7061 Modulus of Elasticity [Mpa] 73000 Coeff. of thermal expansion [1/C°] 19.6×10-6 Ulti