汽车英语Unit 13.pptVIP

Look up these technical terms in the wordlist of this book. Label this illustration with terms in the oval below. Look up these technical terms in the wordlist of this book. Label this illustration with terms in the box. Can you link these explanations with the tyre rating below? 196 — tyre width in millimeters(轮胎宽度mm) 60—— tyre cross-section as a percentage (%) of the tyre width（轮胎横截面/轮胎宽度百分比） R—— radial tyre （星形轮胎） 14—— diameter of the wheel rim in inches（英寸）轮缘直径 88—— two-number code for the maximum permitted load ( here: 560 kilogram)二位数号码最大载重（此处：560公斤） H— letter code for the maximum permitted speed (here: 210km/h) 字母号最高限速（此处：210km/h) Do you know these words? lift mount jack hub screw remove nut hubcap bolt loosen tighten check spare tyre flat tyre wheel wrench correct pressure wheel chock collect boot opposite Here are instructions in twelve steps-but in the wrong order. What is the correct order? ( ) Lift the car with the jack until the flat tyre is just above the ground. ( ) Screw the wheel nuts onto the bolts and tighten them by hand. ( ) Remove the spare tyre, the jack , thewheel-wrench and wheel chocks from the car boot. ( ) Mount the spare tyre onto the hub so that it fits over the wheel bolts. ( ) Remove the hubcap from the wheel and loosen the wheel nuts with the wrench. ( ) Check the spare tyre. If it appears flat, fill it with air up to the correct pressure. ( ) Now use the wheel-wrench to tighten the wheel nuts. ( ) Now remove the wheel nuts and place them in the wheel cover so that you don’t lose them. ( ) Lower the car onto the ground and remove the jack. ( ) Collect all the tools an