hadoop完全分布式安装步骤.docxVIP

本机windows的ip 台式机的ip 笔记本的 linux master ip 3.3台机机 两个linux slave1 slave2 ip 3.100 3.101上传工具保证FTP开启[root@localhost ~]# /etc/init.d/vsftpd restart关闭 vsftpd： [失败]为 vsftpd 启动 vsftpd： [确定][root@localhost ~]#[root@localhost vsftpd]# lsftpusers user_list vsftpd.conf vsftpd_conf_migrate.sh[root@localhost vsftpd]#ftpusers user_list这两个文件中的root用户注释掉 然后 重启 [root@localhost vsftpd]# /etc/init.d/vsftpd restart配置主机名[root@localhost ~]# vim /etc/sysconfig/networkNETWORKING=yesNETWORKING_IPV6=noHOSTNAME=master[root@localhost ~]# hostname master三台主机都配置主机名[root@localhost ~]# vim /etc/sysconfig/networkNETWORKING=yesNETWORKING_IPV6=noHOSTNAME= slave1[root@localhost ~]# hostname slave1[root@localhost ~]# vim /etc/sysconfig/networkNETWORKING=yesNETWORKING_IPV6=noHOSTNAME= slave2[root@localhost ~]# hostname slave2关闭防火墙和selinux[root@master ~]# vim /etc/sysconfig/selinux# This file controls the state of SELinux on the system.# SELINUX= can take one of these three values:# enforcing - SELinux security policy is enforced.# permissive - SELinux prints warnings instead of enforcing.# disabled - SELinux is fully disabled.SELINUX=disabled# SELINUXTYPE= type of policy in use. Possible values are:# targeted - Only targeted network daemons are protected.# strict - Full SELinux protection.SELINUXTYPE=targeted[root@master ~]# service iptables status表格：filterChain INPUT (policy ACCEPT)num target prot opt source destinationChain FORWARD (policy ACCEPT)num target prot opt source destinationChain OUTPUT (policy ACCEPT)num target prot opt source destination域名解析使得master和slave1 slave2 连接对方三台都要做[root@master ~]# vim /etc/hosts# Do not remove the following line, or various programs# that require network functionality will fail. localhost.localdomain localhost::1 localhost6.localdomain6 localhost6 master01 slave200 slave1安装jdk在三个机器上创建文件夹[root@master ~]# mkdir installer[root@master ~]#上传jdk