AC 013 AHU Start-up.docVIP

System Test Certificate系统测试证书 Date 日期 Checklist for Start-up HVAC AHU System HVAC AHU系统启动检查单 Certificate No.证书号 Project 项目 Project No. 项目编号 System Engineer 系统工程师 System Supervisor 系统监督员 Package No 工程包编号 Contractor 承包商 Area Description 区域描述 Room in Area 区域房间号 No AHU Inspection Check List AHU检查单 Y是 N否 REMARKS备注 1 Check that name plate data is correct 检查铭牌数据正确 2 Check that AHU tag No. is correct 检查AHU位号正确 3 All AHU chambers fan, coil and filter section are clean and free 所有AHU室（风机，盘管及过滤器段）清洁通畅 4 Fan impellor is free to rotate 风机叶轮旋转灵活 5 Fan transit block bolts are removed from spring isolators 拆除风机上弹簧隔离器的临时螺栓 6 Pulleys on motor and fan are aligned correctly and belts tensioned 电动机和风机上的皮带轮已正确校正，螺栓紧固 7 Cooling coils are free of damaged and obstructions 冷却盘管是否无损伤无阻塞 8 Filter are cleaned and installed correctly no plastic covering louvre 过滤器清洁且安装正确无塑料异物覆盖百叶 9 Filter frames installed with additional vertical channel supports 过滤器框架已安装并附加垂直槽钢支撑 10 AHU panels airtight at joints soapy water test with air pressurisation AHU板接缝处气密处理（肥皂水风压试验） 11 Fan and motor bearings free and lubricated 风机和电动机轴承灵活、润滑 12 Fab shaft and bearings aligned 风机轴及轴承校正 13 Electric motor level and aligned 电动机找平找直 14 Fan spring anti-vibration mounts sitting correctly with full weight 风机弹簧抗震架可正确满重支撑 15 Doors close properly with double acting handles and sealed airtight 门装配双动把手、气密、可适当关闭 16 Double glazed windows in doors sealed airtight and hinges adjusted 门装配双层玻璃窗、气密、铰链调节 Ductwork Pre-Inspection Check List 管道预检查清单 17 Supply air ductwork complete to enable pressurisation 供风管道完成可增压 18 Return air ductwork complete and blanked off to attain pressurisation 回风管道完成、并密封以增压 19 Fresh air ductwork complete to enable pressurisation complete with EU3 filters inside plenum no plastic sheet cover and filter gauges fitted 静压箱的EU3过滤器（无塑料薄膜覆盖）及过滤器仪表安装之后完成新风管道以增压 20 All branch regulating dampers are installed correctly and fully open 所有支管调节阀已正确安装并完全开启 21 All motorised dampers are installed correctly a