DLT5161.13电力变流设备施工质量检验.docxVIP

盘柜基础安装Cabinet foundation installation工序Process检验项目Inspection items性质Property 质量标准Quality standard 检验方法及器具Inspection method and instrument基础安装Foundation installation 基础型钢安装误差Deviation of foundation section steel installation 不直度Out-of-straight extent＜1mm/m(或＜5mm/全长)＜1mm/m(or＜5mm/whole length)拉线检查Bracing wire check水平度Level extent 用水平尺检查Check with level ruler基础中心线误差Foundation centerline deviation 主要Primary ±5mm用尺检查Check with tape盘基础与地面标高差The distance between panel foundation and ground elevation固定式stationary type ≤10mm用水准仪或连通管检查Check with spirit level or communication pipe 移动式Mobile type与地面标高一致The same with ground elevation 基础布置Foundation arrangement按设计规定According to design specification 对照图纸检查As per drawing to check基础型钢接地点数Grounding points No. of foundation section steel ＞2点＞2 points观察检查Visual inspection 接地线连接方式Grounding wire connection type焊接Welding 接地连接Grounding connection 牢固，导通良好Firm, good conductivity 扳动并导通检查Check through wrench and conductivity 整流逆变类盘柜的安装工序Process检验项目Inspection items性质Property 质量标准Quality standard 检验方法及器具Inspection method and instrument柜体安装Cabinet installation 垂直度Verticality 主要Primary ＜1.5mm/m用铅坠检查Check with sinker 柜面不平度Cabinet surface unevenness相邻两柜边The adjacent two cabinet edges ＜1mm拉线检查Check through bracing 成列柜面Cabinet surface in lines ＜5mm柜间缝隙Gap between cabinets ＜2mm目测Visual inspection 水平误差Horizontal error＜5mm水平尺检查Check with leveling instrument 固定方式Fixed mode 固定式Fixed type 螺接Screw joint 观察检查并扳动检查Visual inspection and check through wrenching 移动式Mobile type 卡子或支撑固定Fixing 牢固Firm 扳动检查Check through wrenching 紧固件检查Fastener inspection 镀锌层完好，螺栓齐全，紧固The galvanized coat is in good condition; bolts are complete, firm.观察检查Visual inspection螺栓露扣长度Length of exposed bolt thread 2扣-5扣2 -5震动场所的防震措施Precautions against shock at shock area可靠Reliable 柜体接地Cabinet grounding 有防震垫的柜体接地The grounding of cabinet with anti-shock pad每列盘有两点以上明显接地There are more than two obvious grounding for cabinet of each column.观察并导通检查Visual inspection and check conductivity 装有电器的可开启屏门接