工序质量评定表(柱、梁钢筋).docVIP

Evaluation of Quality of Construction Procedure Contractor：CATIC-ENG Position：Box culvert/drainage foundation Name of Procedure：Steel Bar 主要工程数量Main quantity of Items to be inspected Serial No. Inspection Items for Appearance Quality requirement Comments 1 Clause 7.1.1 钢筋表面洁净、无锈皮、油渍等污垢。Clean reinforcement surface without rust and oil stain. Meet the requirements 2 Clause 7.3.1 钢筋的品种、级别、形状、规格、数量等均符合要求。Variety, grade, shape, specification and quantity of reinforcement comply with requirements. Clause 7.3.3 成型后的骨架稳定牢固，在安装及浇筑混凝土时不松动或变型。Shaped reinforcement framework is firm and stable with no looseness and deformation during erection and concrete casting. Serial No. Items to be measured Specified value or permitted deviatioin mm 实测值或实测偏差值Measured value or deviation Numbers to be inspected Qualified Numbers Percentage of qualification % 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 1 箍筋及构造筋间距Spacing of stirrups and structural reinforcement ±20 -11 -5 +6 +6 +8 5 4 80 2 Mechanical reinforcement spacing ±20 -10 +9 +7 -15 4 4 100 3 Thickness of protection layer ±10 +6 -5 +11 -6 +8 +5 6 6 100 4 同一截面内受拉钢筋接头占总截面面积Ratio of tensile reinforcement connector within the same cross section to total area of cross section 不大于50% 20% 1 1 100 5 6 7 8 9 10 Crew of handing over Crew of taking over Comments from consultant Signature: Average rate of qualification % 95% Grading Excellent Technical people in charge： Constructor： Inspector： Date: