基于51单片机的电子时钟设计源程序教程.doc

#includereg51.h unsigned char DispBuf[6]; //时间显示缓冲区 unsigned char Disdate[6]; //日期显示缓冲区 unsigned char DisSec[6]; //秒表缓冲区 struct //设定时间结构体 { unsigned char Hour; unsigned char Min; unsigned char Sec; }Time; struct //设定日期结构体 { unsigned char Year; unsigned char Month; unsigned char Days; }Date; struct //设定毫秒结构体 { unsigned char Minite; unsigned char Second; unsigned char MilliSec; }Millisecond; unsigned char point=0; unsigned char point1=0; unsigned char point2=0; unsigned char Daymount; unsigned char Daymount1; unsigned char T0_Int_Times=0; //中断次数计数变量 unsigned char Flash_flag=0; //闪烁标志，每半秒闪烁 unsigned char Flash_flag1=0; //闪烁标志，每半秒闪烁 unsigned char DisPlay_Back=0; //显示缓冲区更新备份，如果显示缓冲区更新则跟闪烁标志不一致 unsigned char DisPlay_Back1=0; //显示缓冲区更新备份，如果显示缓冲区更新则跟闪烁标志不一致 unsigned char i,j; unsigned char SetMillisecond; //启动秒表 code unsigned char LEDCode[]={0x01,0xd7,0x22,0x82,0xc4,0x88,0x08,0xc1,0x00,0x80}; //数码管显示代码 code unsigned char ErrorLEDCode[]={0x01,0xe7,0x12,0x82,0xc4,0x88,0x08,0xc1,0x00,0x80};//绘制错误图纸的数码管显示代码 void DisPlayBuf(); void ChangeToDispCode(); void ChangeToDispCode1(); void changedate(); // 调日期 void displaydate(); // 显示日期 void makedays(); //确定每个月的日期 void runSec(); void delay(unsigned int i); //函数声名 sbit P1_0=P1^0; sbit P1_1=P1^1; sbit P1_2=P1^2; //*************************************************** // Init 初始化代码 // 设定50ms中断一次，注：在Fosc=6M情况下 //**************************************************** void Init(void) { Date.Year=10; Date.Month=12; Date.Days=25; Time.Hour=12; Time.Min=0; Time.Sec=0; TMOD=0x01; TH0=(65536-5000)/256; TL0=(65536-5000)%256; TR0=1; ET0=1; EA=1; } /******************************延时子程序*********************************************/ void delay(unsig