水泥稳定碎石加强垫施工方案.doc

路基水泥稳定施工方案对进行施工，根据试验确定的施工参数组织施工。水泥稳定碎石的施工方案如下：路基交验由业主、监理会同路基施工单位对要交付的路进行严格的验收，验收内容包括：压实度、弯沉值、高程、横坡度、平整度、宽度、中线偏位共七项，每项都认真、细致的检查，符合要求后接收。（2）测量放样放样原则：直线段20米，曲线段10米，放中线桩及边桩高程测量采取闭合测量。放样以后撒上白灰线，灰线包括中线、边线（两条）、引导摊铺机的走向线（两条）共条。（）下承面的清扫及洒水湿润在摊铺前，对下承面彻底清扫干净，确保下承面无杂物，清扫完成后准备施工前视路基情况进行洒水湿润。（）挂钢丝线根据测量确定的高程数据挂钢丝绳，钢丝的松紧度对路面的平整度影响很大，紧钢丝时使钢丝紧绷，并采取负重法（钢丝上挂5kg重物使钢丝的挠度小于5cm为准）测试钢丝的松紧度。（）拌及运输水泥稳定碎石料的拌严格按照试验室出具的配合比执行，试验室派人在拌现场进行指导并随时观测混合料的均匀情况。严格按照试验室出具的配合比执行，试验室派人在拌合现场进行指导（）摊铺采用摊铺机摊铺水泥稳定碎石料。层松铺系数试验确定摊铺机后设一专人对松铺厚度进行检查。在摊铺机后面设专人消除粗集料的离析现象，特别应铲除局部粗料“窝”，并用新料填补。（）碾压碾压按由低到高，先轻后重，先静压后振压的原则进行。直线段，由两侧向中心碾压；超高段由内侧向外侧碾压。每道碾压与上道碾压相重叠1/2轮宽，使每层整个厚度和宽度均匀地压实到98%以上。压实后用光轮压路机赶光、收面，表面无轮迹、隆起，断面正确，坡度符合要求。碾压遍数为7遍，具体工艺为：振动压路机静压一遍；振动压路机轻振一遍；振动压路机重振两遍；振动压路机轻振一遍；3Y18/21光轮压路机碾压两遍。碾压过程中压路机不能在工作面上调头。碾压结束后，碾压表面达到平整密实，无轮迹裂纹、搓板起皮、松散、反弹现象。（）横缝处理（）养生碾压完成后采用覆盖渗水土工布洒水车洒水养生，养生时间不少于7天。覆盖土工布时，确保搭接长度不小于10厘米，采取再用上压砖等方法密封固定，覆盖整个路幅全宽;整个养生期使水泥稳定碎石基层都保持湿润状态养生期间封闭交通。（1）In order to ensure normal teaching order, protecting students healthy growth, ensuring that national (property) is not lost, to prevent or minimize the occurrence of safety accidents, follow the prevent, rescue each other, ensure safety and reduce losses principle, according to the local conditions, make the management system. 1, the principal is the responsibility of school safety, school security under the leadership of President security work leading group. The head teacher to the leadership team is responsible for, implementation of the accountability system. 2, school monthly student knowledge about safety education, education should be diversified in the form every safety education for students of classes per week should be targeted. To carry on emergency issues dealing with education in General, self-help and mutual rescue knowledge. Emergency calls (such as 110, 119, 122, 120, and so on) use common sense in education. 3, the establishment of major accident reporting system. School students report major accident within an hour of education; student run and di