Templifier_and_HeatRecovery.pptVIP

Chiller Plan DesignTemplifier? And Heat Recovery Chiller Design Why Consider Heat Recovery? Green Is Good (For Business) Conservation of Natural Resources Lower Annual Energy Usage Reduce Operating Cost Provide a Good Life Cycle Analysis Heat Recovery Requirements Also during “Warm and Hot months” the plant ask for cooling and heating (sanitary hot water, reheating water…) : HEAT RECOVERY is an efficient, energy saving, solution ! Heat Recovery Requirements Heat Recovery Can Be Used For Preheat Or Charge Mode VAV With Reheat VAV Boxes Require Reheat When Minimum Flowrate Is Reached Generally Occurs In Mild Or Cold Weather (Winter) Can Happen During Morning Warm-up Any Season Constant Volume With Reheat Reheat Used To Warm (12°C) Supply Air As Required By Each Zone Required Even On A Design Day High Reheat Loads In Cold Weather Excellent Choice For Heat Recovery Fancoils Hot Water Used Whenever A Zone Has A Heat Load Four Pipe System Only Most Buildings Require Hot Water And Chilled Water In Winter Excellent Choice For Heat Recovery Condenser Heat Recovery Design Condenser Heat Recovery Design Chiller Condenser Pressure And Temperature Is Raised To 40°C – 45°C Condenser Provides Tower And Recovery Connections Raised By Limiting Cooling Tower Output And Using Three Way Valve Dedicated Cooling Tower Is Recommended Whatever Heat Is Not Claimed By Recovery Is Rejected Through Cooling Tower When No Recovery, Operate Condenser Loop At Normal Temperatures Condenser And Boiler Loops Isolated Tertiary Loop Design Allows Different Flowrates And Temperature Ranges In HR Loop From Boiler Loop Can Reclaim Max. Energy Isolates Loops Pump Only Operates When Required Heat Recovery Design Generally Design Boiler Load Greater Than Design Chiller THR (Total Heat of Rejection) Actual Design Heat Recovery Rate Requires Annual Energy Analysis Almost Never Boiler Or THR Design Capacity Load Will Be Met By Combination Of HR And Boiler THR = 1.25 x Chiller Capacity Only One Chiller Need B