毕业设计（论文）-梯模型PLC控制系统设计.docVIP

毕业设计（论文） 题目：西门子S7-200型PLC模拟三层电梯控制 专 业 电子电气工程系 班 级 电信05301班 姓 名 指导教师 2008年5 月 电梯模型PLC控制系统设计 摘 要 电梯的电气系统由拖动系统和控制系统两部分组成。目前电梯设计使用可编程控制器(PLC)，功能变化灵活，编程简单，故障少，噪音低。维修保养方便，节能省工，抗干扰能力强，控制箱占地面积少。当乘员进入电梯，按下楼层按钮，电梯门自动关闭后．控制系统进行下列运作：根据轿厢所处位置及乘员所处层数。判定轿厢运行方向，保证轿厢平层时减速。将轿厢停在选定的楼层上；同时，根据楼层的呼叫，顺路停车，自动开关门。另外在轿厢内外均要有信号灯显示电梯运行方向及楼层数。 关键词：电梯模型 PLC 程序设计 Elevator model PLC control system design abstract Elevators electrical system is composed of the dragging system and the control system two parts. At present the elevator design uses programmable controller (PLC), the function change is flexible, the programming is simple, the breakdown are few, the noise is low. The service maintenance is convenient, the energy conservation labor saving, antijamming ability, the control box area are few. When the crew member enters the elevator, presses down the floor button, after the elevator door automatic shut-off. The control system carries on the following operation: Locates the position according to the sedan theater box and the crew member locates the layer. The determination sedan theater box movement direction, guarantees the sedan theater box even strata time deceleration. Stops the sedan theater box on the designation floor; At the same time, according to floors call, stops on the way, autoswitch gate. Moreover must have the signal light inside and outside the sedan theater box to demonstrate the elevator movement direction and the floor number. key word: Elevator model PLC. keyword: Elevator model ，PLC，Programming. 目 录 TOC \o 1-3 \h \z HYPERLINK \l _Toc163739737 第1章 前言 PAGEREF _Toc163739737 \h 1 HYPERLINK \l _Toc163739738 第2章 电梯概述 PAGEREF _Toc163739738 \h 1 HYPERLINK \l _Toc163739739 2.1电梯的起源与发展 PAGEREF _Toc163739739 \h 1 HYPERLINK \l _Toc163739740 2.2国外电梯的情况 PAGEREF _Toc163739740 \h 2 HYPERLINK \l _Toc163739741 2.3国内电梯的情况 PAGEREF _Toc163739741 \h 2 HYPERLINK \l _Toc163739742 2.4 电梯技术发展趋势 PAGEREF _