emu 0404 数字 模拟 同轴 辫子制作.docxVIP

How to build a custom EMU-0404 breakout cable for high end audio applications.If you own an EMU0404 and use it for audiophile listening, then its pretty obvious the stock breakout cable is pretty weak. Its flimsy and of poor quality, and then you need a weird 1/4 to RCA to hook it up to your amp...no fun.So far it sounds great! Heres what I used to make mine, though you can substitue lower or higher quality parts where you see fit:- Silver-plated copper mil-spec wire, teflon housing- WBT 4% silver solder- Tinned copper braided shielding- Radio Shack DB9 D-Sub connector- Radio Shack D-Sub Metal Hood- Dayton Audio Pro-Fi locking RCA plugs- Some Techflex heatshrink to make it prettyTo start, youll need the pinout for the breakout cable. Here it is, with the important ones in bold (from the Head-Fi forums courtesty of Stroog).版本一：1: nothing2: right output3: left output4: left input5: right input6: right output ground7: left output ground8: left input ground9: right input ground版本二：其实是一样的，这卡是平衡输出Analog 模拟接口 1 - n/c 2 - OUT-R - tip 3 - OUT-L - tip 4 - IN-L - tip 5 - IN-R - tip 6 - OUT-R - sleeve 7 - OUT-L - sleeve 8 - IN-L - sleeve 9 - IN-L - sleeveDigital 数字接口 4 - SPDIF - out - gnd 5 - SPDIF - out - signal 6 - SPDIF - in - signal 13 - SPDIF - in - gndSo what exactly does that mean? Well, if you get the Radio Shack D-Sub connector each pin is marked. Just solder each wire to the correct pin. Otherwise, heres a handy diagram I came across online:The top left pin is #1, the next one over is #2, and so on. When soldering to the back of the DB9 connector remember it will be in reverse, so the top right will be #1!Instructions are below - please feel free to comment or email me if you have any questions.* If you would like, contact me for a quote to build this cable for you using the same configuration I used for this tutorial.就是普通9针串口会了这个，M-Audio的delta卡同理，我只给出引脚定义就是普通15针串口Here is the pinout for the Delta 44/66.1 - analog out1模拟输出声道1，左声道2 - analog out2模拟输出声道2，右声道9 - shared gr