在设备分解时机械密封故障的维修3.pptxVIP

Troubleshooting mechanical seals at equipment disassembly 在设备分解时机械密封故障的维修3Steven_TianjinTHE CARBON FACE碳面Phonograph finish on the carbon face.碳面上留声机式抛光A solid product was blown across the seal face. This happens in boiler feed water applications.固体产品通过密封面吹出.这通常在锅炉供给水的应用中发生THE CARBON FACE碳面Chemical attack of the carbon.碳的化学侵蚀You are using the wrong carbon. Something in the product or the flush is attacking the carbon filler. Switch to an unfilled carbon such as Pure grade 658 RC or C.T.I. grade CNFJ.你使用错误的碳.产品中的一些或冲洗正在攻击碳的填充物.转换为没有填充的碳,象纯度等级658RC,或C.T.I等级CNFJYou are trying to seal an oxidizing agent. Oxidizers attack all forms of carbon including the unfilled type. The carbon combines with the oxygen to form either carbon monoxide or carbon dioxide.你试图密封氧化剂.氧化剂攻击所有类型的碳,包括没有填充的类型.碳与氧结合形成一氧化碳或二氧化碳Some forms of de ionized water will pit and corrode carbon faces一些形式的去离子水将点蚀或腐蚀碳面THE CARBON FACE碳面Cracked or damaged carbon face.碳面的破裂或损坏The product is solidifying between the faces. Carbons are strong in compression but weak in tension or shear. This problem is common with intermittent pumps each time they start up. 产品在面之间凝固.碳在压缩时强壮,但在张力或剪切时脆弱.这是一个通常与间歇泵每次启动相联系的问题Excessive vibration can bang the carbon against a metal drive lug. 过大的振动能够撞击碳到一个金属驱动凸缘上A cryogenic fluid is freezing a lubricant that was put on the face. 低温学液体冷冻放在面上的润滑剂The elastomer is swelling up under a carbon or hard face. 在碳或硬面下的弹性体肿胀THE CARBON FACE碳面The shaft is hitting the stationary face or the rotating seal face is hitting a stationary object.轴撞击硬面或旋转面撞击静止的物体Mishandling.违反运行规程Poor packaging. The lapped seal faces should be able to survive a 39 (one meter) drop.不好的包装.重叠密封面应在一米高的坠落中幸存Ice is forming on the outboard side of the seal and preventing the seal from moving to compensate for face wear.在密封的外侧形成冰,并且阻止密封的移动来补偿面的磨损THE CARBON FACE碳面A coating is forming on the carbon face:一个涂层在碳面形成A change in temperature. Many products solidify at temperature extremes. 一个温度的变化.许多产品在极端温度时凝固The product is taking a pressure d