ji.ppt

Ex.6-1 A pair of standard spur involute gears has a module of 5mm, pressure angle ?=20? , centre distance a=350mm, transmission ratio i12 =9/5. Calculate the numbers of teeth(Z1 and Z2), reference diameters(d1 and d2), addendum diameters(da1 and da2), base diameters(db1 and db2), tooth thickness s, spacewidth e, pressure angles on the addendum circles(?a1 and ?a2), the radii of curvatures of tooth profile on the reference circles(?1 and ?2), and the radii of curvatures of tooth profile on the addendum circles(?a1 and ?a2). 列出公式、待入数据、得出结果三步缺一不可！ Ex.6-2 How many teeth would an external standard spur involute gear have when its dedendum circle and its base circle coincide? Which one is bigger as the number of teeth increases ? Ex.6-3 Shown are a pair of involute profiles C1 and C2 with the common normal n-n passing through the contact point K. The pinion 1 is a driver. (1)?? Draw the two base circles and two pitch circles. (2)?? Label the theoretical line of action N1N2 and actual line of action B1B2. (3) Label the working pressure angle ?’ and pressure angle ?K at the point K. (4) Label the actual working section DG of the profile C2.D点常出错！ (5) Find out point M2 on the profile C2 which will engage with point M1 on the profile C1. Ex.6-4 Shown are a pair of involute pinion and rack with their pitch circle and pitch line. Determine graphically the actual line of action B1B2, the actual working section EF on the tooth profile of the pinion 1 and the actual working section GH on the tooth profile of the rack. Ex.6-4 Shown are a pair of involute pinion and rack with their pitch circle and pitch line. Determine graphically the actual line of action B1B2, the actual working section EF on the tooth profile of the pinion 1 and the actual working section GH on the tooth profile of the rack. G 点常出错！ Ex.6-5 A pair of external spur gears have the parameters as: Z1=10, Z2=27, m=10mm, ?=20?, ha*=1, c*=0.25, working center distance a’=185mm. Neither gear has cutter interfe