《气缸盖零件工规程及工艺装备设计》毕业设计论文.docVIP

。。。。学校 毕 业 设 计 （论 文 ） 题目《气缸盖零件工艺规程及工艺装备设计》 系 别 专 业 班 级 姓 名 学 号 指导老师（职称） 日 期 摘 要关键词：工序规程；工艺装备；专用夹具；组合机床 Abstract Geometric Machine Design---3 Figure 1 Card ① “process map parts to be machined,”It is the combination of the main basis for design of machine tools, which is to create the use ,maintenance and adjustment of the machine processing of the important technical condition ② schematic drawing, which is the Tool fixture, multi-axle, hydraulic design of electrical installations and general components choice is primarily raw data, it is to adjust machine tools, cutting tools, and test basis. ③ drawing contact and the relationship between exercise and test the components relative to the machine location and linked to whether they meet the processing requirements, common components of the right to choose whether, and to further spindle boxes, fixtures and other special parts, spare parts procide the basis for the design. ④ relatice producticity calculations card,which is used to reflect the processing of machine tools to complete the time required for performing this exercise, cutting parameters, machine producticity and machine loading rate. Combination machine tool spindle box design, the design according to specific requirements, from general-purpose components, whose main role is to be processde parts according to requirements, schedules and location of the spindle power and movement from the motor or drive components pass the spindle, so as to be requirements of speed, machine tool spindle box choose 400?00, with the middle drice shaft dricen spindle drive. Fixture design choices in the aforementioned positioning datum premise, with the swing lever platen clamping structure, clamping force experienced operator can guaranee that. The content of the