operationmanual.docVIP

OPERATION MANUAL DIGITAL pH MONITOR Before putting the pH monitor to use, please check the local power voltage, and read this manual carefully. FRONT BACK PANEL DESCRIPTION 1) pH display 2) pH4 adjustment knob 3) pH7 adjustment knob 4) pH electrode BNC input terminal 5) Power cord with plug 6) Fuse OPERATING (CALIBRATION) 1) Connecting AC power supply. (Make sure the correct voltage.) 2) Connecting the pH electrode into the pH input terminal socket. (in back side) 3) Put the pH electrode into the standard buffer solution pH7.00. Waiting for a few seconds and adjust the pH7 knob until the display reading exact 7.00. 4) Take away the pH electrode from buffer solution, and clean the electrode with fresh water. 5) Put the pH electrode into the standard buffer solution pH4.00. Waiting for a few seconds and adjust the pH4 knob until the display reading exact 4.00. (You also can calibrate pH10.00. Use the buffer solution pH10.00 instead of pH4.00 buffer solution.) 6) Take away the pH electrode from buffer solution, and clean the electrode with fresh water. 7) Put the pH electrode into the water what you want to measure. When use a new pH electrode, user has to repeat step 1) to 7) for calibrating when put a new pH electrode to use. CLEANING AND MAINTENANCE 1) It must to pull out the power plug (turn off) when cleaning the controller. 2) Please wipe the housing with drying when cleaning, do not wipe with wetting. 3) It had better to calibrate the pH electrode during 3-6 weeks to make sure the reading within accuracy when measuring in a long time. pH electrode input BNC terminal should plug in pH electrode only. Please use this pH monitor away from the electronic ballast SPECIFICATION Measurement：pH：0 to 14 pH Accuracy at 25℃：±(0.1%+ 2 digits) after calibrating Impedance：1012 ohms Calibration Knob：External pH7 (CAL.) and pH4 / pH10(SLOPE) Display：pH 0.56 LED, 3 1/2 digits Operating Temperature：0 to 50℃ (32 to 122℉) Operating Humidity：Max.