SECTION 10 75 00, FLAGPOLES.docVIP

SECTION 10 75 00FLAGPOLES SPEC WRITER NOTE: Delete between //// if not applicable to project. Also delete any other item or paragraph not applicable in the section and renumber the paragraphs. PART 1  GENERAL 1.1 DESCRIPTION Fixed high dimensional, ground set, uniform conical taper, seamless tube flag pole. 1.2 RELATED WORK A. Excavation and backfill: Section 31 20 00, EARTH MOVING. B. Concrete for ground set flagpole: Section 03 30 00, CAST-IN-PLACE CONCRETE. 1.3 SUBMITTALS A. Submit in accordance with Section 01 33 23, SHOP DRAWINGS, PRODUCT DATA, AND SAMPLES. B. Shop Drawings: Flagpole, including base and finial ball, showing construction and installation. C. Manufacturers Literature and Data: Flagpole 1.4 APPLICABLE PUBLICATIONS A. The publications listed below form a part of this specification to the extent referenced. The publications are referenced in the text by the basic designation only. B. American Society for Testing and Materials (ASTM): A167-99 (R2009) Stainless and Heat-resisting Chromium-Nickel Steel Plate, Sheet and Strip B209-07 Aluminum and Aluminum Alloy-Sheet and Plate B241/B241M-10 Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded Tube PART 2  PRODUCTS SPEC WRITER NOTE: Make material requirements agree with applicable requirements specified in the referenced Applicable Publications. Update and specify only that which applies to the project. 2.1 MATERIALS A. Aluminum, Extruded: ASTM B241, alloy 6063  T6. B. Aluminum, Plate and Sheet: ASTM B209, alloy ll00. C. Stainless Steel: ASTM A167, Class 302 or 304. 2.2 FABRICATION A. Fabricate flagpole of seamless extruded aluminum tube, uniform conical taper of approximately 1 in 70 (one inch in every 6 feet). Taper shall not exceed 50 percent of outside diameter of pole. When flagpoles are shipped in more than one section, provide selfaligning sleeves for field joint. B. Base: Aluminum plate or stainless steel, of stock design similar to that shown. C. Finial Ball: 2 mm