BAM、BFM高压并联电容器中英文简介.docVIP

Series high voltage shunt capacitor Applicationa The products are applied to 50Hz or 60Hz AC electrical power system for powerirmpr-oving and will be according to the national standard GB 3983.2-89 (high voltage shumt capacitor) and inter national IEC 60871-1. Service conditions Altetude lower than 1000m,ambiedt temperature -40℃~+400℃; No strong mechanical vibmfom at installing place.No corrosive gas,inductive dust,and inrlammable and explosive media in the ambient environment; The medium between poles should resist one of below tests in 10 seconds; Frequency AC voltage:Un(~)=2.15Un DC voltage:Ut(-)=4.3Un The insulation of the terminals and cases should resist below voltage; To extend the life of capacitors,the capacitor should always run in rated voltage; Capacitor should resist a 2.2 Un or below first peak and last 1/2 cycle of transitional over voltage; Capacitors can tolerance 1.3 In stable over current because of voltage increase or high harmonic.For those capacitors with highest to lerance ,the over current can reach 1.43In. The deviation of rated and actual capacitance should be -5%~+10%,The ratio of highest and lowest capacitance of any two terminals should not be higher than 1.08. When capacitors are at the frequency rated voltage,the loss tangent (tgδ)at 20℃ is 0.0005. For those capacitors which contain discharge capacitor,it is possible to reduce the voltage from peak voltage to 75V within to minutes.If reducing to SOV with Smins is needed,it should be indicated in ordering. Three-phase capacitors are star configurations.Discharge resistors are added in each phase. Applicable Standards GB/T 11024.1-2010 National Standard{Rated Voltage 1 KV or Higher AC Power System Shunt Capacitor} IEC60871-1:2005 International Standard{Shunt Capacitor} 高压并联电容器 用途： RH-高压并联电容器主要应用于50HZ或60HZ交流电力系统中用以改善功率因数，产品性能符合GB3983.2-89《高电压并联电容器》及国际标准IEC60871-1。 使用条件： 海拔高度不超过1000m。环境空气温度-40℃~+400℃； RH-高压并联电容器安装场所无剧烈的机械振动，无有害气体及蒸汽、无导电性及爆炸性尘埃； 电容器极间介质应能承受下列二种试验电压之一，历时10s。 工频交流电压：Ut（~）=2