Instrument calibration.docVIP

Instrument calibration and test standard instrument should have certificate of metrological verification effectively, its fundamental error absolute value should not be more than a third of the calibration instrument basic error absolute value. 7. The instrument calibration and test standard instrument should have certificate of metrological verification effectively, The absolute value of its basic error should not be more than one - third of basic error absolute value is calibrated instruments. 8. The instrument calibration and test condition, the way of project, should comply with the provisions of the design documents. 8. The instrument calibration and test condition, The way of The project, should comply with The provisions of The design documents. 9. Conditions are not for the construction site for the calibration of the instrument, to validate the validity of the certificate verification. 9. The Conditions are not for a construction site for the calibration of the instrument, to validate the gnosis.xml.validity of the certificate verification. 10. Design files regulation banning oil and instrument in the calibration and test of degreasing, must according to its rules. 10. The Design files regulation banning oil and instrument in the calibration and test of degreasing, must according to its rules. 11. A single instrument calibration point should be within the scope of the instrument full range evenly, generally should not be less than 5. Loop test, instrument calibration point should not be less than 3 points. 11. A single instrument calibration point should be within the scope of the instrument full range evenly, generally should not be less than 5. Loop test, instrument calibration point should not be less than 3 points. Second, a single instrument calibration and test requirements Second, a single instrument calibration and test requirements 1. The pointer display instrument calibration and test, and shall meet the following requirements: 1. Th