乐迈移动技术说明.docVIP

M17米格移动技术说明 M17 Miego Mobile Technology Description 产品描述(Product description) 此产品主要适用于供电在5V1A以下移动电器产品使用 This product is mainly applied to supply power for mobile electronics products below 5V1A. 手机 （主要配置为原装苹果充电USB线） Mobile phone (The main configuration is for the original Apple charging USB cable) 2.MP3，MP4，蓝牙产品 Mp3,Mp4 and Bluetooth products 3.数码相机 Digital cameras 产品性能Product Capability 按下按键开关，显示电池容量 Press the switch key , the battery capacity displays. 使用锂离子电芯，300次循环充放电后电池容量80% Use the lithium-ion batteries,circularly charge-discharge more than 300 times, it ensures more than 80% capacity. 500mA输入 容量2400mAH 500mA Input Capacity 2400mAH 通过搭配不同的USB输出转接口，可为绝大部份5V产品充电 USB output port can charge 5V products through the adapter. 智能保护芯片：过充保护，过放保护，过载保护，短路保护 Chipset with smart protection : Overcharge protection, over discharge protection, overload protection, short circuit protection. 产品外壳采用IML工艺，不易刮花、脱色 The product shell uses the IML process 6.产品有效率（移动电源储能与手机充电转换率）≧85% ≧ 85% efficiency 功能简介Function Introduction 主按键功能：主按键包含功能有开机、低功耗模式、电池容量显示、手电筒功能（部份型号配备） Press the control button to power on / off (will be low power mode / standby), is also the battery capacity indicator button, and it will open the DC / DC output 5V, if not detected to load within 15 seconds, automatically turn off the DC / DC to go into standby mode,and open the flashlight function。 开机：短按主按键为开机，开机时LED同时长亮5秒，移动电源进入开机状态，开机后LED灯会显示当前电池电量，输出接口自动开始5V输出，如果15秒内未检测到充电设备则自动关闭输出，进入到待机模式 Shortly press the button of power on,and the LED will also show, a long bright five seconds into the boot state, the LED will display the current battery charge after boot, start to output 5V, if not detected to the load within 15 seconds, automatically turn off output to go into standby mode. 给外部设备供电：开机后插入需充电设备即可开始给外部设备供电，LED闪动3次表示当前已检测到需充电设备并开始充电。撤出充电设备，移动电源LED灯会自动显示当前电源剩余容量，5秒后关闭LED显示，同时延时15秒后，电源将自动进入待机/低功耗模式。 Inserted load can charge to an external device after the boot sta