直升机使用说明书.docVIP

Important instruction: Because our product is using gyro technology ,so please according to the following method to operate it . turn the power switch of the remote control to “on”, then pull the throttle operation lever to the lowest place. connect the helicopter’s power line properly, turn the power switch to “on”, place the helicopter on the ground steadiy, right now please keep the helicopter motionless, after 5 minutes the gyro complete verity, then it can fly normally. part names 平衡杆：balanced beam 连接扣：connected button 上风叶： wind leaf 下风叶：Downwind leaf 上风叶座：Wind leaf seat 下风叶座：Downwind leaf seat 尾风叶：tail fan 充电口：charging port 起落架：undercarriage 指示灯：LED 油门：accelerograph 频率切换：Switching Frequency 电源开关：Power Switch 左转、右转、前进、后退：turn left/turn right/forward/backward 左转、右转（微调）：turn left/turn riht(fine tuning) 充电线：rechargeable line 组装遥控器 assemble the remote control The means of installing the batteries: open the battery cover on the back of the remote control, according to LED pole in the cell box, put 4 AA alkaline batteries correctly(Batteries need to buy) Tips: when installing the batteries, you must pay attention to the positive and negative pole and the positive and negative pole of the cell box , don’t counter-attire them. Do not mix use old and new batteries. Do not mix use different kinds of cells Power battery charging instructions turn the switch of the helicopter to “off” (1)charge modeA: Remote charging: Connect the charging plugs to the charge port of the helicopter, the LED of the remote control turn green(the time of charging is about 40 to 50 miniutes), when it complete charging, the light turns red. (2) charge mode B:USB charging: insert USB charging line into USB port of the computer, when the charging line indicator on, connect the USB charging plug to the charge port of the helicopter, at this moment the light is off(the time of charging is about 40 to 50 miniutes), when the light of the charging line lit, the charging is completed. Flight