直线返回型前座椅装配线技术说明(英).docVIP

JOHNSO CONTROLS Straight-line Return Front Seat Build Line Technical Specification Shanghai Minghua Overhead Chain Conveyor Co., Ltd. August 29, 2004 Straight-line Return Differential Chain Conveyed Front Seat Build Line Technical Specification Overall layout Build line adopts double-decked differential chain flexible conveyor, the upper deck is used for workstation operation while the lower deck is used for pallet return. Traveling speed for trays at the upper and lower decks is 18 M/min, which is governed via frequency conversion. Total length of lines is 30335 mm. Build line holds 15 operating workstations, 15 storing workstations, the interval between workstations is 915 mm; At two ends of build line are the workstations for hoist to access into other deck. Build line is equipped with 36 trays with outside dimension of W620×L620×H270 each, the plant height is 800mm (from line bottom to tray bottom). Inner space of the plant for tray operation is 290mm maximum, external width is 820mm. 1.3 Every operating workstation is provided with tray releasing button, manual and auto knobs and tray locker. Set the button in Manual Mode for manual operation or in Auto Mode for unattended operation. The tray shall stop and be locked automatically when in place, which shall be released by simply pushing down the workstation releasing button after completed operation. Storing workstations are not installed with electric controller, the tray of storing workstation shall be released automatically into the operating workstation provided that the front operating workstation has idle space. Stopper and electric wrench for specific workstation allow for electric interlocking, only when electric wrench satisfies the specific moment value and output the qualified signal can it be unlocked, others are operated automatically. 1.4 Workstation for trays to go up or down for access to other deck is installed with AUTO/MANUAL commutation switch and FAST STOP switch. Operation of tray