配合起重电动机带负载试转.docVIP

配合起重电动机带负载试转 电动机就位，安装接线 Motor in place, installation of wiring 联系起重人员，配合起重将电动机运至原装位置。 - contact lifting personnel with lifting electric chance to original position. 联系机械班组找中心，找好后将电动机地脚螺丝带紧，注意靠背轮的间隙保持在3-5mm之间。 - contact mechanical team to find center, after looking for a good motor bolts with tight, pay attention to the backrest wheel clearance between 3-5 mm. 联系热工接上测温元件接线，并接上电动机电源线、加热器接线和接地线，接线时注意让电源线与接线盒保持足够的空全距离，不与外壳直接接触，接线盒密封严密，包扎接线柱外露部分绝缘。 / contact the thermal temperature measurement component wiring is connected, the power cord and connected to the motor, heater wiring and grounding wire, wiring note keep the power cord and junction box enough empty the whole distance, dont direct contact with shell, terminal box sealed tight, bandaging terminal exposed part of the insulation. 11 电动机空载试转 S step motor no-load running in 11 检查现场工作完毕后，确认工作人员已撤离现场，靠背轮明显分开，影响空载试转的相关设备已恢复好，电动机具备空载试转条件，工作负作责人填写和送签电动机空载试转联系单，与工作票一起交至运行控长，申请送电空载试转，试转前注意提前通知热工部分解除相关闭锁条件。 / inspect the site after the completion of the work, make sure the staff have been evacuated from the scene, backrest wheel clearly separate, good influence no-load test transfer related equipment has been restored, the motor with no load test conditions, negative responsibility person to fill in and send signed work motor no-load running in contact list, together with the working ticket delivered to run long, apply for sending no-load test, try to turn attention to advance notice before the thermal part terminate the relevant lockout condition. 电动机空载试转120分钟及以上，测量空载电流在20%-40%以内，三相不平衡量不大于平均值的10%，电动机振动、振速、温度和噪声符合质检要求。 - motor no-load running in 120 minutes or more, measurement within 20% 40% no-load current, three-phase unbalance is not greater than the average 10%, vibration motor, vibration velocity, temperature and noise in accordance with quality requirements. 空载试转时边转边加油脂改善轴承润滑，检查电动机各部分无过热和异常。 - when no-load running in turn while improve bearing lubrication grease, check each part of the motor