除油工艺-中英文版.docVIP

船舶管路清洗工艺程序Flushing Technology Procedure of Piping1、根据管路清洗图，将泵、循环药剂池和清洗管路连接好。According to chemical flushing sketch, the pump、cycling medicament pool and chemical treatment piping must be connected to heat coil pipes. 2、按照化学药品厂家要求，将中性除油粉、中性脱脂剂和淡水按照5%、5%、90%的比例配好，加入到临时水柜中。According to chemical manufacturer’s requirement，dissolve the neutral deruster、neutral degrease medicament(as attached) into clean freshwater in proportion with 5%、5%、90%.Then fill the liquid into the temporary water tank.3、启动泵，进行循环清洗。清洗时间约为3小时。清洗时应使用木锤对清洗管路进行连续敲击，以提高清洗效率。Start the pump, circulating cleaning water.The flushing treatment time is about 3 hours.During flushing the piping should be hammered with wooden hammer for improving the flushing effect.4、目测检查是否有油污。如还有油污，应按照步骤3继续清洗，直到管道内壁无油污为止。Check up with visualization if it already exits oil .If it has,repeat step3 until clean.5、向管道内重洗加入淡水进行循环清洗（淡水中应加入一定比例的防锈剂对管道内部进行防锈处理）。原则上约为2小时，最后将管道内的淡水全部泄放。Refill the clean freshwater into piping and start flushing.During flushing,dissolve the rust inhibitor(as attached) into freshwater.Normally the time is about 2 hours approximately.After rinsing,drain the piping completely.6、使用通过压缩空气对管路吹除干燥，并向船东报检。Blow and dry the flushing piping with compressed air.Then inspect to class and owner.