refrigeration piping.pptVIP

Refrigerant Piping Condenser Location Session Objectives Outline the limitations of refrigerant pipe runs and the location of units and air cooled condensers. Air cooled condenser piping Refrigerant circulating in the system contains oil系统制冷剂循环含油 Piping design must ensure good oil return管道设计必须保证回油性好 A standard system can have a pipe run up to 30m, refer IOM for pipe sizing.一般系统管道达到了30m长，参考IOM来确定管径 Longer pipe runs are possible with extended piping kit and correct pipe sizing. Extra oil must be added to compressor.长管道布置应尽可能用烟瘴组件和合适的管径。油必须加到压缩机中 Condenser~ level or above Slope gas piping in direction of gas flow在气体流动方向上的气管有一定倾斜 Install traps each 7.5m in vertical pipe riser.垂直管道上每7.5m设一个回油弯 Insulate hot gas line in underfloor space.在地板下空间隔离热气 If higher than 20m rise ~ use extended piping kit.如果高出20m使用延长组件 Do not oversize pipes ~ leads to excessive refrigerant charge不要使用过粗的管子，导致制冷剂充入量过粗 Condenser~ below Maximum height difference is 5m. Do not exceed this limit最大高度差5m不要超过这个高度。 keep liquid pipe rise as close to condenser as possible在靠近冷凝器测液管有向上的斜度 Liebert Manufacturing Australia Learning Conference ~ 12-13th March 2002 Liquid line Check valve + Condenser coil Evaporatorcoil Dehum soleniod valve Thermal expansion valve Liquid line soleniod valve + Charging port Filter drier Sight glass Hot Gas bypass valve(single compressor model) Discharge line Scroll compressor Service valves Traps * each 7.5m of vertical lift Distributor / feeder tubes Sensing bulb + components are part of optional extended piping kit. Check valve is supplied loose for field fitting at condenser shutoffvalve * * components are not supplied by liebert, but are recommended for proper circuit operation maintenance * *