智能机写IMEI号工具使用方法1018.pptVIP

Pre-conditions Set clean boot only can be used with following conditions Sw load is 1048MP or later (For Yusu) Sn writer is v2.1052.0 or later * Steps to set clean boot Step1: Open Sn Write tool, select Smart phone in “Target Type” item Step2: Select USB VCOM in “ComPort” item * Steps to set clean boot Step3: Enter to System Config, available options for set clean boot are “Barcode”, “ IMEI”, “ BT ”, “ WIFI MAC Address”, “Wifi EEProm Copy”, we take “ IMEI” as a example. Step4: You should select “Dual IMEI” option if you want to set clean boot in “Write IMEI”, because SW can’t support Dual IMEI is 1032MP. * Steps to set clean boot Step5: Select Modem database（MD_DB_1) and AP database(AP_DB),then Click “OK”button * Steps to set clean boot Step6 Click “Start” button.Then input IMEI,then press enter key or click “OK” button in input console. * Steps to set clean boot Step7: Connect to your phone and antomatically power on your phone to enter META mode do the required operations Step8: When write log shows backup ok and “write Result Indicator” turns green means Write IMEI and set clean boot OK. IMEI input console will pop up allows you do same operation in next phone. See next page for detail information. * Steps to set clean boot *