WI for New Orman Heater.pptVIP

WI for Omron Heater controller(E5CN)(SLT series M/C) Wong Hon Fai 09, March, 2012 Outline Parameter Initialization Factory Setting Parameter Setting Alarm Function Auto PID setting Sealing Shoes Temperature Offset Parameter Initialization Factory setting Alarm Function Communication Setting Turn on communication between SLT400 and heater Control Period and Thermocouple Type Sealing Shoe Temperature Calibration Apparatus Basic calibrated temperature measuring unit E.g. Fluke 16 Multimeter with 80BK integrated DMM temperature probe as shown in fig. 11. Measurement Procedure Set the target temperature to 100 degree C. Place the TC probe inside the seal shoe calibration hole Wait for 15 minutes. Record the meter temperature. Repeat step 1 to 3 by changing the temperature to 150 and 200 degree C. Sealing Shoe Temperature Calibration 2 point Method 4 Point Method Temperature offset setting Temperature offset setting Temperature offset setting (Cont.) Protect Setting ASM Pacific Technology Ltd. ? 2008 Return to Factory Setting -169 Factory setting Press set the alarm function RUN 5 5 On Press more than 3 seconds 0 PID 300 6 1 1 0.2 1 OFF Press more than 3 seconds to set the offset value -169 INS2 ON Upper offset Lower offset Press + for protect setting OFF ASM Pacific Technology Ltd. ? 2008