Charger design specification.docVIP

STG-VX1 TRAVEL CHARGER設計規範 Design Spec. Of STG-VX1 1.概述 1. Description 1.1目的 Purpose 本文描述了本廠所STG-VX1的電氣、安全等方面的設計要求. This document describes the electrical and safety design requirements of the Design CPA. 1.2功能 Function 專為CPA CHARGE所提供DC-DC轉換功能. It provides the DC-DC switching function for STG-VX1 2.電氣規格 Electrical specification 2.1輸入電壓:AC90~264V,50~60Hz Input voltage: AC90~264V, 50~60Hz 2.2 消耗功率 Power loss 2.2.1最大輸入功率(在滿載的狀況下): 低於8.5W Maximum input power: with full load: Below 8.5W 2.3充電器的工作效率＞60% Working efficiency ＞60% 2.4輸出電壓和電流 Output voltage and current 2.4.1空載電壓: Voltage with no load: 輸出電壓: (當在10mA負載時,溫度25℃)4.25±0.05V Output voltage (With 10mA load @25℃): 4.25±0.05V 2.4.2負載電流: 550mA±100mA Current with rated load(with output voltage3.6V@25℃)4: 550mA±100mA 2.4.3工作區域 Working Area ×××××××××× 4.25V ×××××××××× Forbidden area 3.9V 2.5短路保護 Short circuit protection 當充電器的正負極短路時,充電器都不能毀壞或有損傷,由短路恢復正常後,充電器應該正常工作. When positive and negative polarities are shorted, no damage and any hazard occur. Once abnormal condition is removed, charger should keep working as usual. 2.6 RIPPLE AND NOISE電壓空載及工作狀態時,小於100mVp-p (PEAK TO PEAK) Maximum output ripple: less than 100mVp-p (peak-peak), under no load and rated load condition. 最大輸出漣波:用DC電源供應器輸入固定電壓14V:輸出3V-4.25V的漣波 Maximum output ripple: With input 14V and ripple voltage 3 to 4.25V 2.7沖擊響應 Impingement Response 充電器的輸出電流以200mA/us的變化率從100mA上升到1100mA或從1100mA跌落到100mA,充電器的輸出電壓應保持在規定的工作區域內. When output current of charger change between 100mA to 1100mA at a rate of 200mA/us, output voltage of charger should be kept inside the working area. 2.8輸入電流無負載: 在無負載的狀況下,測量輸入電流是否超出範圍.低於10mA Input current with no load: Measured with no load and over the range of input voltage. Below 10mA 2.9指示燈在有額定電源輸入時需保持恒紅. The