Polar镜面喷漆手法作业指导书.docVIP

一.目的/Purpose 确保能按客户的品质要求进行生产,保持批量生产的稳定性,避免制程中批量性不良的 产生.To ensure the quality of the customer requirements for production and maintain the Stability of production and avoid the batch process for the selection ill. 二. 适用范围/Scope 适用于贝尔罗斯 广州 二厂镜面喷涂. Aapply in Perlos Guangzhou plant 2 Mirror spraying. 三. 参考文件/ References 无  No 四.责任/ Responsibility 生产线巡检: Production Line Inspection  负责接收信息与反馈To receive information and feedback 负责样品的接收与保存Samples for the reception and preservation 生产线技术员: Production line technician 负责对生产的整体进行确认 Responsible for the overall production of confirmation 程序：/ Procedure 1.作业人员必须戴手指套,拿取镜片时应拿两侧. Workers must wear sets of fingers, get to be with both sides of the lens. 2.检查来料素材. Check incoming material. 3.将保护膜划成长方形,与镜片大小相符. The protection of membrane divided into rectangular, in line with the size of the lens. 4.将长方形的保护膜贴在镜片反面,必须与镜片粘合. To protect the membrane rectangular lenses affixed to the opposite, with the lens sticking. 5. 将保护好的镜片进行两面除尘,每面来回除尘3-4次. Good protection for two lenses dust, dust each side return 3-4. 6.放入吸盘上,先放里面,再放外面,镜片需与夹具吻合. Add sucker, the first release inside, add outside lenses need to coincide with the fixture. 7.双手大拇指分别同时按住左右绿色开关. His hands were also pressed the thumb around the green switch. 8.取出已喷好的镜片,先取外面的镜片,再取里面的,放在待检区. Spraying has removed a good lens, the first lens from the outside, and another inside the seizure question on the district. 9.检验人员按照检验指导进行检验 The examiner tested with guidance for examination. Name of the document Polar 镜面喷漆手法作业指导书 Polar mirror painting operations guide MGZ 00.00.00 In force as of 31.08.2007 Prepared by / date Reviewed by / date Approved by / date Rev. Mingtai Chen/31.8.07 Alan Yang Charlie Hou 01