UPLCSchoolCh9换针_SFX.pptVIP

Database Overview and Login 第九章卸除和更换进样针部件 卸除和更换进样针部件 Post Needle Replacement 灌注进样针筒 针内针设计 何时才需要换针？ 更换针: 性能维护. 即使更换洗针溶剂也无法去除交叉污染. 当内针弯曲或者针头受损时 或者针被异物堵住 针的去除 针的去除 针的去除 针的去除 针的 去除 穿引针 进样针定位Z轴位置 卡上金属套管 通过金属卡套固定针的位置 针架的安全固定位置 将针连上六通阀 换针后的任务 在换针后,需要执行一下操作: 校正内针的位置 校正外针的X,Y,Z的位置,并进行洗针 灌注自动进样器. 校正进样针密封圈. 测定针和系统的体积. 校正内针的位置 测定针和定量环的体积 总结 更换针组件: 是PM的部分 如果更换洗针液也不能消除污染物的鬼峰 当针弯曲或受损 当针被堵塞 进行必要的相关测试 校正 XYZ 灌注进样器 校正密封圈 测定系统体积 In the sample compartment, loosen the red thumbscrew on the needle mounting bracket. Push the needle latch back to release the needle mounting cylinder from its mounting cavity. Warning: To prevent injury or equipment damage do not touch or press the end of the sample needle. Doing so can cause a puncture wound and damage the needle. Lift the needle tip out of the white plastic guide at the bottom of the XYZZ mechanism. Remove the needle assembly from the sample compartment. For a more detailed explanation of removing and replacing the needle, please refer to the section Maintaining the System in the Waters ACQUITY UPLC System Operators Guide. These are examples of the dual needle design. Remove the protective sleeve from the needle tip. Insert needle tip from outside to inside of the instrument into the guide tube (not shown). A replacement guide tube is included in the needle kit. Gently push the needle assembly into the sample compartment. From inside the sample compartment, take hold of the needle assembly tubing as it enters the chamber from above. Needle tip should be inserted into the needle guide at the bottom of the XYZZ mechanism. Note: Z axis calibration is not optional. The ferrule mounting cavity secures the top mounting ferrule. Insert the needle ferrule into the ferrule mounting cavity. Close latch assembly and coil needle. Seat needle in groove Place black sleeve protector under the thumbscrew and tighten thumbscrew. Note: The needle should be captured in the machined channel provided. Be certain that the thumb screw d