制作双分区SD卡.docVIP

双分区SD卡的制作 首先在windows下用wondows自带的磁盘管理工具格式化SD卡，如果SD卡有两个分区（如图1），可以先删除未知分区，然后再新建磁盘分区（新建分区时可以直接按向导操作，只要选择FAT32格式）再格式化。 图1 将SD卡接入虚拟机，如图2 图2 打开终端，用mount命令查看挂载设备，如图3 图3 执行umount卸载SD卡，如图4 图4 进入mkcard.sh所在的目录，如图5 图5 执行命令：sudo ./mkcard.sh /dev/sdb,得到如下输出信息 记录了1024+0 的读入 记录了1024+0 的写出 1048576字节 1.0 MB 已复制，1.24278 秒，844 kB/秒 Disk /dev/sdb doesnt contain a valid partition table DISK SIZE - 座机电话号码40 bytes CYLINDERS - 244 Checking that no-one is using this disk right now ... OK Disk /dev/sdb: 244 cylinders, 255 heads, 63 sectors/track sfdisk: ERROR: sector 0 does not have an msdos signature /dev/sdb: unrecognized partition table type Old situation: No partitions found New situation: Units cylinders of 座机电话号码 bytes, blocks of 1024 bytes, counting from 0 Device Boot Start End #cyls #blocks Id System /dev/sdb1 * 0+ 8 9- 72261 c W95 FAT32 LBA /dev/sdb2 9 243 235 1887637+ 83 Linux /dev/sdb3 0 - 0 0 0 Empty /dev/sdb4 0 - 0 0 0 Empty Successfully wrote the new partition table Re-reading the partition table ... If you created or changed a DOS partition, /dev/foo7, say, then use dd 1 to zero the first 512 bytes: dd if /dev/zero of /dev/foo7 bs 512 count 1 See fdisk 8 . mkfs.vfat 3.0.7 24 Dec 2009 mke2fs 1.41.11 14-Mar-2010 文件系统标签 rootfs 操作系统:Linux 块大小 4096 log 2 分块大小 4096 log 2 Stride 0 blocks, Stripe width 0 blocks 118080 inodes, 471909 blocks 23595 blocks 5.00% reserved for the super user 第一个数据块 0 Maximum filesystem blocks 座机电话号码4 15 block groups 32768 blocks per group, 32768 fragments per group 7872 inodes per group Superblock backups stored on blocks: 32768, 98304, 163840, 229376, 294912 正在写入inode表: 完成 Creating journal 8192 blocks : 完成 Writing superblocks and filesystem accounting information: 完成 This filesystem will be automatically checked every 39 mounts or 180 days, whichever comes first. Use tune2fs -c or -i to override. 在虚拟机下卸载SD卡 重新将SD卡接入虚拟机，出现如图6图标，双分区SD卡制作完成。 图6