西安邮电大学毕业设计(论文)撰写要求及规范.doc

西安邮电大学毕业设计（论文）撰写要求及规范 为使学生掌握撰写技术报告和科研论文的基本方法，统一毕业设计的技术标准和规格要求，所有说明书和论文报告必须按以下格式编写～ 6、量和单位 要严格执行GB3100～3102：93有关量和单位的规定（具体要求请参阅《常用量和单位》.计量出版社，1996）； 单位名称的书写，可以采用国际通用符号，也可以用中文名称，但全文应统一，不要两种混用。 三、论文的印刷要求 毕业论文用纸一律为A4大小 1、封面： 毕业论文封面采用全校统一印刷格式。 2、论文字体、字型及字号要求 (1)大标题 1 XXXX 黑体小三号1行 (2)一级节标题 1.1 XXXXX 黑体四号0.5行 (3)二级节标题 1.1.1 XXXXXX 黑体小四号0.5行 (4)三级节标题 a. XXXXXXX 黑体小四号0.5行 (5)四级节标题 (1) XXXXX 宋体小4号0.5行 (6)五级节标题 1) XXXXXX 宋体小4号0.5行 (7)内容 XXXXXXXXXXXXXX 宋体小4号20pt 表题与图题 表2.1 XXXXX 宋体小4号20pt (8)参考文献及篇眉 XXXXXXXXXXXXX 宋体5号20pt 3、段落及行间距要求 （1）正文段落和标题一律取“固定行间距20pt”，段前间距为3～） a special tool to measure half a point the rotor shaft runout and simultaneous measurement of two coupling flutter testing, it should meet the requirements. Install the coupling housings to ensure embedded rotor coupling within a concave shoulder, and rotor clearance meets the design requirements. 6.4, 6, wearing construction technology of generator rotors demonstration 6.4.6.1 construction preparation and conditions through the stator before loading check and confirm to confirm air tightness test of the stator and stator mechanical, electrical, instrumentation and control and other related work had been completed. Internal cleaning of stator, high power vacuum the surface of the stator. Stator and rotor magnetic Center drainage is complete. In conjunction with the quality, mechanical, electrical and other relevant persons to finally cleaning check the stator, which is clean and free of any debris. Worn rotors check and confirm confirm before loading the rotor air tightness test, electrical test work has been completed. In conjunction with the quality, mechanical, electrical and other relevant persons to finally clean the rotors checked, its interior is clean and free of any debris. By quality, mechanical, electrical and other professionals to conduct an examination of the rotor, confirm the wear condition of the rotor. Special equipment inspection and rotor through the preparation tool before loadi