JCP -- Rubber Plastic Bath Mat Testing Protocol -- 9.11.13.docVIP

Evaluation Citation / Method No. of Samples Criteria Results Rating SUPPLEMENTAL PROTOCOLS Note: Additional cost, sample size TAT may be required if testing to 1 or more supplemental protocol is necessary. Please refer to the above referenced supplemental protocol s for additional information. * California Proposition 65 JCPY-AN-PTCL-06572-USA - The sample should be reviewed against the requirements of California Proposition 65 to determine if additional testing or labeling is required. For samples that fall under the scope of CAProp 65 requirements with testing limit s but does not contain appropriate labeling refer to labeling section for detail , actual testing will be conducted. Otherwise, actual testing is not required and report as Pass if the sample contains appropriate labeling. * Non-CPSIA Requirements CPSD-GB-PTCL-08443-US - All samples shall be reviewed against the requirements of Non-CPSIA Requirements supplemental protocol to determine if additional testing or labeling is required. * Memory Foam JCPY-SL-PTCL-01185-US - [If applicable] The sample should be reviewed against the requirements of Protocol to determine if additional testing is required. LABELING The final production approved artwork and packaging is allowed to submit in mock up or PDF form. It must be submitted and sized to scale per the applicable legal requirements. Childrens products that require a warning label are excluded. ** Fair Packaging and Labeling Act 16 CFR 500 1 -Manufacturer, Packer, or Distributor’s Name Address City, State Zip -Product Identification -Net quantity of contents shall be expressed in terms of weight or mass, measure, numerical count, or combination so as to give accurate information to facilitate consumer comparison U.S. and metric units ** Uniform Packaging and Labeling Regulations NIST Handbook 130 Part IV A 1 -Manufacturer, Packer, or Distributor’s Name Address City, State Zip -Product Identification -Net quantity of contents shall be expr