C语言程序设计验报告1.docVIP

《C语言程序设计实验报告》 实验一：了解程序开发环境 实验目的 了解C语言程序的开发环境，掌握C语言源程序的编辑、编译、执行的过程。 了解不同的C语言程序开发环境，并在不同的环境下编辑、编译、连接和运行C语言程序。 通过运行简单的C程序，初步了解C语言源程序的特点。 实验要求 阅读和掌握本实验内容所给的全部程序。 保存和答应出程序运行结果。 熟悉Turbo C 2.0 环境、Borland C++ 环境、Visual C++环境。 实验内容及成果展示 调试运行《C语言程序设计实验教程（第二版）》P39 1. 2. 3. 4． 实验心得 了解了程序在Turbo C、Borland C++、Visual C++环境下的编译、执行情况，熟悉了上述程序开发环境。 认识到上述环境的运行功能及特点。 实验过程中注意到许多细节问题，在输入源代码时一定要细心、认真，否则会给调试工作带来许多不便。 遇到无法执行的情况，学会将上一个程序释义后，再将该程序执行。 在实验过程中要注意分号的使用问题，不可以漏写。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jack uses the same pump, evenly. B) left to set u