安徽工业大学移教务系统手机软件(安卓版)使用说明.docVIP

移动教务系统（安卓版）使用说明 下载移动客户端 安装 操作 3.1主页面 点击快捷图标进入移动教务，可以看到六个模块及一个设置。 3.2通知公告 点击通知公告，可以进入教务处实时通知公告，查看列表和详情，如下图。 点击公告标题，进入公告明细页面。 3.3个人中心（用户登录） 教学评价、课表信息、考试信息、网上选课都需要身份认证后才能操作。在点击个人中心按钮后，出现如下界面，通过身份选项，选择学生还是教师身份，然后输入自己在学校教务系统中的用户名和密码，便可登录成功。 注意：第一次使用，输入身份信息后，系统将自动保存身份信息在手机中，除非你点击注销按钮。 3.4课表信息 登录成功后，点击课表信息，将出现如下界面，显示最新的课程信息。 3.5成绩查询 此模块需要输入学号、身份证号，再选择需要查询的学年和学期，便可查询该学期的所有成绩。点选“记住我”复选框，下次查询时便不需要输入学号和身份证信息。 3.6教学评价 点击教学评价图标进入你需要评价的课程列表，点选需要评价的课程进入评价页面，依照评价指标顺序点选评价级别，评价结束后点击提交按钮结束此门课程的教学评价。 3.6考试信息 点选考试信息图标可以浏览本学期的考试安排。 3.7网上选课 点选网上选课图标，可以看到待选课程及相关信息列表。点选你要选的课程，选择开课教师，点选教师后，点击选定按钮，选课成功会返回成功信息。退选课程与选课同样的操作流程。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To