铝合金门窗扇以门窗玻璃的安装方法.docVIP

铝合金门窗扇以及门窗玻璃的安装方法的安装是有一定的质量要求的，尤其是其门窗扇以及门窗的安装方法，要知道门窗扇以及门窗玻璃的安装可以说是铝合金门窗安装的主体了，其安装质量至关重要，到底门窗扇以及门窗玻璃的安装方法有哪些呢？ 1、门窗扇和门窗玻璃应在洞口表面装饰完工后安装，这是说明门窗扇以及门窗玻璃的安装是有一定的时间顺序要求的。  2、窗在门窗框安装固定后，将配好玻璃的门窗扇整体安入框内滑道，调整好框与扇的缝隙即可。 3、平开门窗在框与扇格架组装上墙、安装固定好后再安玻璃，即先调整好框与扇的缝隙，再将玻璃安人扇并调整好位置，最后镶嵌密封条、填嵌密封胶。 4、地弹簧门应在门框及地弹簧主机入地安装固定后再安门扇。先将玻璃嵌入门扇格架并一起人框就位，调整好框扇缝隙，最后填嵌门扇玻璃的密封条及密封胶。 总之，在安装的过程中一定要注意密封性能，这样才能保证后续门窗在使用过程中的优质隔音隔热的效果当然如果有专业的安装人员那自然是更好，建议消费者最好选择大型品牌铝合金门窗企业进行铝合金门窗的购买，因为一般大型品牌企业都会提供专业的技术团队进行上门安装服务，并且还有一定的质量保证日期。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measu