销售系统操作流(销售结算员).docVIP

XX供应链系统 销售结算员 操作手册 适用岗位： 销售公司 适用流程： 销售公司业务流程 2.5 销售结算员系统使用手册 首先，销售结算员登陆销售公司帐套，输入用户名和密码，点击登陆，进入系统： 销售公司结算员首先点击供应链——销售管理——价格结算单——维护价格结算单，对价格结算单信息进行录入： 查到对应的单据，，可以查看优质优价的计算结果，如下： 其次，销售结算员对发票进行结算，点击供应链——销售管理——销售发票——发票维护： 业务流程选择：普通销售，点击“增加”——“库存销售出库单”： 然后系统会弹出一个“查询条件”的菜单，输入查询条件，点击确定。 选中单据，点击确定。 按照销售发票对发票信息进行维护，点击保存——审核： 审核之后，系统会自动生成销售公司的销售应收单和销售成本结转单，联查结果： 至此，销售系统流程结束。 manufacturers drawings bolt fastened in the cylinder and outer cylinder. Cylinder cylinder in the drain pipe installation and measuring component leads. 6.4.4.3 blade carrier, partitions and lower installation check the sealing ring of the seal and springs, which shall conform to the technical requirements manufacturers drawings. Cylinder gasket on the mounting brackets supporting the Group assembled, the lugs shall be no Burr on the surface, and other debris. Department suite in place to measure surface and inner cylinder surface height difference, compared with the original values confirm the location. 6.4.4.4 lower bearing and thrust bearing installation clean bearing and bearing, thrust bearing joints, clean them with a thin layer of turbine oil, and then lifting it to bits. 6.4.4.5 high and middle pressure cylinder over it to the end (for high pressure rotor and low pressure change flange gasket without connection unit) rotors and rotor flange gasket connection and there is no connection, so the rotor in place cases, rotors in place must be high and middle pressure cylinder together with the Chamber over it to the end. Jack in the box that are installed on a push-pull device of adjusting the high and medium pressure cylinder to end over and around to set up indicators to monitor data, general data about the difference must not exceed 0.02mm. To prevent cylinder about out of sync over the situation, take the following measures: a) over Jack uses the same pump, evenly. B) left to set up indic