移动电源基本常与使用指南.docVIP

翼通移动电源销售指南 什么叫移动电源? 移动电源，也叫“外挂电池”、“外置电池”、“后备电池”、“数码充电伴侣”、“充电棒”、“充电棍”，所有手机都有充电保护电路，充电的前80%左右，为快速直充。就是标准电压下，完电流强度的充电大约达到电池容量的90%以上时，就会转为涓流充电，直至充满。充满后自动切断充电、用转接头22. 电芯有等级之分吗？ 根据电池的质量和时效性分为三个等级A电B电和C电。A电——全新聚合物电池，B电——库存超过三个月或者拆机电池，C电——废旧电池。特别注意的是C电虽然便宜，但有严重的质量问题，B电价格对低廉，但衰退非常快。在经济允许的情况下，请购买A电移动电源23.翼通移动电源的电芯是用什么级别的？ 翼通移动电源的电芯都是聚合物电芯，原装A级品。 24.普通锂离子电芯的优缺点？ 普通锂电的优点为：因为发展时间比较久远，电池的价格非常低廉。缺点：废旧翻修电池较多，因为工艺原因，问题率和不及格率居高不下。体大，重量重，使用寿命短和有可能引起爆炸，这是非常致命的缺点，目前主流的移动电源都逐步淘汰这种电芯。 翼通中国区营销服务中心 2011-12-22 翼通移动电源使用指南 第 1页，共 5页 position for future reference. Installation using special lifting pole rotor 6.4.4.6 rotor lift, box spirit level to check the rotor axis neck of Yang, on both sides of the rotor should be lateral raises and numerical deviation of ≤ 0.10MM, qualified before the official lifting. Hoisting of the rotor dynamic and static clearance should be measured, rotors check clearance to prevent rotor colliding. 6.4.4.7 stationary blade carrier, diaphragm and sealing upper cylinder on the inside and install the mounting bolts, bolts and bolt holes in the surface should be coated with molybdenum disulfide. Follow the manufacturers stamp marked to install good sealing ring and spring. Check the sealing ring and spring plate, shall conform to the technical requirements manufacturers drawings. Bolt: ... Measurement with measurement tools, special tools, temporary connection bolts and connection tool equipped and in good condition. The rotor shaft to have fixed, such as thrust, bearing plates fixed installation, in case of wear of the rotor is too large. The coupling gasket check measurements: measured data processing according to gasket, clean the coupling gasket surface clean and Burr-free, check the coupling gasket thickness data, shim thickness deviation of ≤ 0.02mm, parallel degree deviation of ≤ 0.02mm. Coupling temporary bolts ready: preparing 4-8 bolt diameter coupling bolt hole diameter 0.5-1.0mm. 6.4.5.2 shaft coupling 6.4.5.2.1 General requi