中国省级行政区廓图.docVIP

中国省级行政区划轮廓图自治区 自治区 浙江省 北京市 重庆市 上海市 天津市 浙江省 浙 杭州安徽省 皖 合肥福建省 闽 福州江西省 赣 南昌山东省 鲁 济南河南省 豫 郑州湖北省 鄂 武汉湖南省 湘 长沙广东省 粤 广州海南省  海口四川省 川或蜀 成都河北省 冀 石家庄 贵州省 贵或黔 贵阳 山西省 晋 太原 云南省 云或滇 昆明 辽宁省 辽 沈阳 陕西省 陕或秦 西安 吉林省 吉 长春 甘肃省 甘或陇 兰州 黑龙江省 黑 哈尔滨 青海省 青 西宁 江苏省 苏 南京 台湾省 台 台北 内蒙古自治区 内蒙古 呼和浩特 新疆维吾尔自治区 新 乌鲁木齐 宁夏回族自治区 宁 银川 西藏自治区 藏 拉萨 广西壮族自治区 桂 南宁 北京市 京 北京 天津市 津 天津 上海市 沪 上海 重庆市 渝 重庆 香港特别行政区 港 香港 澳门特别行政区 澳 澳门 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1 hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2 supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3 pipe supports and hangers part plant prod