在县深入学习实科学发展观活动总结大会上的讲话(修改).docVIP

巩固和扩大学习实践活动成果 为在新起点上再创广丰新辉煌而努力奋斗 ——在全县深入学习实践科学发展观活动 总结大会上的讲话 倪美堂 （2010年4月14日） 同志们： 根据中央和省、市的统一部署，今天，我们召开全县深入学习实践科学发展观活动总结大会，主要目的是对学习实践活动进行全面总结，动员全县各级党组织和广大党员进一步巩固和扩大学习实践活动成果，真正把科学发展观贯穿到今后各项工作中去，为实现在新起点上再创广丰新辉煌提供有力保证。 下面，我讲三点意见： 一、精心谋划，有序推进，全县学习实践活动取得明显实效 在全党开展深入学习实践科学发展观活动，是党的十七大作出的重大战略部署。紧紧围绕“党员干部受教育、科学发展上水平、人民群众得实惠”的总要求，牢牢把握“坚持解放思想、突出实践特色、贯彻群众路线、正面教育为主”的原则，把开展学习实践活动与落实“三保一弘扬”、积极应对国际金融危机冲击、保持经济平稳较快发展紧密结合起来，精心组织部署，顺利完成了第二、第三批学习实践活动。整个学习实践活动进展顺利，实现了预期目标，取得了明显成效 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements relat