焊接309班毕设计任务书.docVIP

焊接技术及自动化专业毕业设计（论文）任务书 班级：焊接309班 姓名： 学号：14309 一.设计题目：编写水轮机磁轭圈工艺高2100mm，外圆直径10米，厚度165mm，母材为Q235c，均布四条焊缝，双V形坡口 3.质量要求：? 焊缝等级为一级，控制焊接热输入小于50KJ/cm???????????????????? ⑵焊前破口检验合格，焊接区域及附近50mm范围内清理干净??????????????????? ? ⑶焊接时，采用多层多道焊，单条焊道宽度在15—20mm范围内??????????????????? ? ⑷焊接时，采用分段焊接，对称施焊，控制焊接变形。磁轭圈磁轭圈磁轭圈磁轭圈磁轭圈磁轭圈 of vision. 3, build, fitting in with the urban master plan in Yibin city rapid rail transit long term network, as well as the vision of Yibin city, and future development of rail transit network. 4, Yibin city, preliminary rail traffic levels service levels, system model, and technical standards. 5, to ensure that network can be implemented. 6, stable conditions for planning and supporting of Yibin city track traffic construction and formation of rail transit industry, provide conditions for the start-up and development of rail transit in Yibin city. 1.7 technical course technology is the projects research program and research ideas. Technology reflects the various stages in the process, logical relations between various levels, research, techniques and phases. Network planning process the whole process can be divided into four parts, namely, background research, network architecture research, planning and implementation of research and programming interfaces. Figure 1.7-1 Yibin city rail transit network planning technology roadmap planning interface is mainly responsible for network planning interface with follow-up planning tasks. Network planning Urban planning system in a transitional position, online network planning is completed, will be carried out as soon as possible the following planning projects: 1, detailed control of the land of rapid rail transit network planning; 2, the partitioning for network planning; 3, joint planning of rail transport and urban transport in other ways; Detailed technical courses see below. Figure 1.7-2 General technology route figure 2nd chapter City status and development plan