教学常规管理工汇报.doc

教学常规管理工作汇报 自从教育局开展“教学常规管理规范化学校达标”活动以来，我校高度重视，召开中层以上领导和全体教师会，传达文件精神，解读细则要求，落实人员责任，细化指标体系落实，制定我校“教学常规管理规范化学校达标”活动方案。紧紧围绕《新民市教学常规管理规范化学校达标细则》，我校提出“为学生终身发展奠基”这一办学理念，以“外塑形象、内强素质、强化管理、和谐发展教学质量是教育的生命线，提高教学质量，是广大学生、家长的迫切愿望是学校发展的基石，学校必须始终坚守“质量为根本”的意识，将主要精力投入到提高教学质量上来。 在今年。 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction guide pin coupling with process end closed. The back wheels slowly tightened, when 2mm or so, with standard white bars where two back wheel bolt hole measurement above and below, confirm two back wheel bolt hole concentricity. Then, th