智能电子产品课标准.doc

《智能电子产品设计与制作》课程标准 课程名称：智能电子产品设计与制作 课程代码： 建议课时数： 90 学分：6 适用专业：三年制应用电子技术高职专业 1前言 1.1课程的性质 关键词：课程地位、主要功能、与其他课程关系知识技能与）0% 评价学生完成相关任务过程中的执行情况，完成相关任务效果，小组协作能力，交流沟通能力、自主解决问题能力 30 小组互评 20% 产品质量与性能 20% 教师评价 40% 2 智能流量计设计与制作 个人自评 20% 30 小组互评 20% 产品质量与性能 20% 教师评价 40% 3 电动车控制器设计与制作 个人自评 20% 40 小组互评 20% 产品质量与性能 20% 教师评价 40% 总评 100 5.其它说明 本课程标准主要适用于高等职业技术学院。 [附]执笔人：钱仁君 审核人： 制定（修订）日期：2009.12.15 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction