未入编老师：人交流中心职称评定填报流程.doc

人才交流中心职称评定填报流程 领表： 1、携带《介绍信》《职称证》《聘任证》等个人证件。 2、领取《河南省中小学教师专业技术职务任职资格评审表》一式两份，评审须知一份，年度考核表最少4张（这个别忘了领）。 准备材料（需盖章的地方都红字说明）： 代理合同书（介绍信）一张。盖章 《专业技术职务任职资格评审材料真实性保证书》一式两份（办公室有，签字盖章即可）。盖章 “公开、展示、考核、评议、监督”报告一份（办公室打印）和教学评价报告（自己书写打印）。都要盖章 年度考核表（是从交流中心领回来的那种）。盖章 学历证、学位证、任职资格证、聘任证（注意我们只填了两年，要再填两年，并盖章）、计算机证。 打印个人业务自传不少于1000字，2份。 《河南省中小学教师专业技术职务任职资格评审表》一式两份，第一页右下角联系方式单位电话和个人电话都要填，单位是0371第11页所有栏目，第12页，第14页第一栏盖章 发表在CN杂志上的论文以及论文检索页（如何检索参见评审须知）。杂志上发表论文页折角并在姓名处盖章，论文检索页盖章 优质课证书。 辅导奖证书。 照片。 评审简表A3纸打印22张（可以先用A4纸打印然后再扩大复印），以及评审简表个人信息的U盘。（这个非常重要，具体制作办法评审须知上有）22张评审简表右下角都要盖章 附录：评审简表填写效果图（共4张图片） center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its val