班组安全生产规化管理要求.docVIP

班组安全生产规范化管理要求 班组是直接从事生产的基本单位，同时也是安全事故最可能发生的地方，要抓好安全管理工作，必须从班组长入手、从班组入手。班组安全生产规范化管理具体相关要求如下： 一、班组安全生产目标 　　班组在生产劳动过程中应始终把安全工作放在首位，实行安全目标管理。班组安全生产目标主要有： 　　（1）不发生人身未遂或轻伤及以上事故； 　　（2）不发生人员责任造成的设备异常及以上事故。 　　安全目标的实现要求班组不断加强自身建设，建立健全以落实岗位责任制为中心的安全制度，开展经常性、多样化的安全学习、宣传教育和岗位练兵活动，使员工熟练地掌握本岗位的安全操作技术及安全作业标准，不断提高安全意识、自我保护能力以及处理突发性事故的能力；同时，班组每一个成员自觉遵章守纪，确保不发生违章、不发生差错，努力做到“四不伤害”（不伤害自已不伤害他人,不被他人伤害,保护他人不被伤害)对休假1个月以上人员、工伤休假复工人员、已（未）遂事故责任者、“三违”人员安全教育。计划、布置、检查、总结、评比 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction guide pin coupling with process end closed.