10和16米后预应力空心板张拉计算书.docVIP

10/16米后张预应力空心板张拉计算书 工程概况 水牛线大修工程k0+431.241炉上桥、K0+800长青桥位于山东省莱西市牛溪埠镇。k0+431.241炉上桥上部结构为10米后张预应力空心板,共9块，其中中板3块，尺寸为9960*1240*600。边板6块，尺寸为9960*1240（1620）*600。预应力筋为φ15.2钢绞线。中板采用φ15.2-4，边板采用φ15.2-5.混凝土采用C40，混凝土数量47.79m3. K0+800长青桥上部结构为16米后张预应力空心板,共36块，其中中板30块，尺寸为15960*1240*800。边板6块，尺寸为15960*1240（1745）*800。预应力筋为φ15.2钢绞线。中板采用φ15.2-3和φ15.2-4，边板采用φ15.2-4和φ15.2-5.混凝土采用C40，混凝土数量317.88m3. 预应力筋张拉力计算 根据设计要求，每根钢绞线的张拉力为1395×140=195.3KN，则对于3-θS 15.2钢绞线，每束张拉力为195.3×3=585.9KN。 对于4-θS 15.2钢绞线，每束张拉力为195.3×4=781.2KN，对于5-θS 15.2钢绞线，每束张拉力为195.3×5=976.5KN。 因为预应力筋呈曲线布置，张拉力为P=Pj(1-e-（kx+μθ））））） coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 1