抠图利器KnokOut滤镜使用教程.docVIP

抠图利器KnockOut滤镜使用教程（抠蜻蜓） 教程使用版本PS7.0? KNOCKOUT 2.0 我们现在就要把这只蜻蜓抠出来。在图层对话框中将背景拉到新建的小标上，建立一个新的图层如图1。然后选择滤镜-KNOCKOUT 2 ，抠图滤镜KNOCKOUT的界面就会弹出来，如图2。 ?图1 图2 3．可以选择放大镜，让画面都在窗口里。然后选择外部选区工具，沿着蜻蜓的外部画一条轮廓线。再选择内部选区工具在蜻蜓不通明的躯干处画出轮廓，如图3，4。 ?图3 图4 4．然后选择上方工具栏中的大头针，如图5 ?图5 5．凡是它点过的地方，都是你确定应该是不透明的地方，譬如翅膀的网格，翅膀根部等。当有些地方看不清时，可按L键，就会出来一个放大镜。点不用点太多，在关键部位，关键颜色，大范围的点一些就可以了，如图6。 ?图6 6．将Detail条的滑块推到4，最高的精确设置，然后点击下面的箭头按钮。这时，你就会看到去了背景的蜻蜓，替换原来背景的颜色可以在旁边的颜色框中选择，如图7，8。 ?图7 图8 7．你如果还想看看蜻蜓在图片上的效果，可以选择颜色框下面的背景图框，从中选择一幅图片，如图9。 图9 8．如果对图片还有些不满意的话，可以对图片反复修改，增加、减去透明或不透明的点、还可以用画笔或橡皮涂擦，也可以用针管注入一些颜色……我这里就不一一介绍了。9．当你感觉到满意的时候，选择File-Apply，就又回到了PS的界面，原来的新图层，就只剩下了那只蜻蜓，如图10。 and performance test copies of the record. If necessary, review should be carried out; 4 for spring hangers included simple spring, hangers and constant support hangers it should also be recognized as setting and locking of loads. 5 check the surface quality, folded layering and without cracks, rust and other defects. 5 after completion of the test and control drawing number one by one, by series baled. Color alloy steel parts, the parts marking installation location and rotation about the direction you want. 7.3.14. hangers installation 7.3.14.1 hanger layout a. a clear design of hanger should be installed strictly in accordance with the drawings and designs shall not be installed wrong, missing, etc. B. own arrangement of piping support and hanger set and selection should be based on comprehensive analysis of general layout of piping systems; cold installation of steam pipe with particular attention reserved for compensation of thermal expansion displacement and orientation. C. support systems should be rational to withstand pipe loads, static load and incidental load; reasonable piping displacement; guaranteed under various conditions, stress are within the allowed range. Strength, stiffness, and meet requirements to prevent vibration and soothing water, without affecting the adjacent equipment maintenance and other piping insta