2013福安心健康培训实施方案.docVIP

2013福安市中小学教师心理健康培训实施方案 一、培训培训 姓名 所属班级 观看时长 作业数体会数 评论数互动评论数 全部班级 6:00 ≥1 ≥4 ≥2 ≥60 72课时合格标准 序号 姓名 所属班级 观看时长 作业数体会数 评论数互动评论数 全部班级 8:00 ≥2 ≥6 ≥2 ≥60 附件一：课程目录 附件二：优秀学员的评价标准和奖励 2013-10-15 附件二：优秀学员的评价标准和奖励 一、优秀学员评选标准 1、按时完成所有课程的相关学习要求； 2、作业或体会优秀且均为原创； 3、评论数、被评论数完成质量高； 4、参加主题研讨活动，发布的帖子受到广泛关注； 5、优秀学员每班1-2名，可自荐。经审核确实优秀，可适当增加； 6、经网上公示获得广泛认同。 二、优秀学员奖励 1、海西教育网将授予优秀学员荣誉证书一份； 2、优秀学员写一篇自我成长类文章并附上本人近照（注：word、照片文件名为学员姓名），以邮件形式，邮件名称写《优秀学员文章》发送至haixijiaoyuwang520@163.com，海西教育网将在《教师风采》栏目中发表。 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. .2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper