东吴人寿内装项工程监理交底.docVIP

东吴人寿内装项目 工程 监理交底 内容提要： 一、工程概况 二、项目监理部管理结构图 三、施工组织设计的审查和基本要求 四、材料设备进场报验 五、工序报验 六、监理工程师指令单、联系单、通知单 和监理工程师指令/通知回复 七、安全生产和文明施工 八、监理例会制度 项目监理部（章）： 专业监理工程师： 总监理工程师： 日 期：　　　 2011年9月1日 　　　　　 江苏省建设厅监制 前 言 为确保东吴人寿内装项目高质量地如期完成，苏州城投项目投资管理有限苏州城投项目投资管理有限公司 东吴人寿内装项目监理交底 coupling Centre shall be checked, the second poured concrete strength of more than 70%. In the process of reaming or boring, apart from the special provisions in factory, does not allow any work that may affect the coupling Centre, such as irrigation, to cylinder connections to flood the condenser pipes and so on. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Mounting bolts should be added lubricants, typing gently with a small hammer, not too loose or too tight, packed the bolts with the corresponding seal screw hole should be marked. 6.4.5.4.2 coupling reamed and pairings is close to the diameter of bolt bearing good hinge holes, dressed with a good two coupling bolts before you can move the rotor, boring-reaming hole in turn. Coupling bolts must be tight coupling is symmetrical diameter, in boring, reaming, two bolts out. Well boring, hinge bolt hole flange with coupling of vertical, not oblique. Due to the coupling bolts in accordance with hinge holes corresponding to the diameter of the screw holes one by one after processing, processing back bolt installation location cannot be changed, so according to bolt after the actual weight difference of nut and lock washer to match. General requirements for coupling two symmetrical diameter bolt, nut and lock washers total weight difference should not be greater than 10 g and knocks stamped mark. (See Figure 18) The coupling bolts apply lubricant, and then gently with copper home, not too loose or too tight. Bolt Assembly is finished, symmetr