E28数控箱操作明书(英文)A5版本.docVIP

E28 Technical Manual This technical manual main narration single axle economy numerical control system E28 technical characteristic and the detail, the technical parameter and the pattern, the project parameter can only establish by the technical personnel, cannot open gives the general operators. The illustration below shows the E28 control panel. Key Operate Introductions Number Key Name Function property 1～10 0～9 numeric key 11 decimal point sign 12 positive/minus sign 13 Delete edit 14 Exit the current operation edit 15 upward edit 16 downward edit 17 left shift edit 18 right shift edit 19 Start or end run control 20 Motor slow/fast switching control 21 click enter to complete an input edit 2．Function operational specification 2.1 Manual processing Illustraton In standby mode,Press the left direction key() or right direction key()to move cursor,you may choose manualoperation , automatic,programming,parameters main menu, The selected menu will be the show in reverse. After choose manual menu, select key into the manual processing mode, At this point X target position is show in reverse, press “enter” into edit state, Press numeric keys to set the position of X, then click enter key to confirmed and switch to Y target location set. Use the same method to set Y position. Press enter key to finish setting. After complete the X, Y position setting, press start/stop button, if the front input within the scope provided in the system, the system would in the light of first Y-axis then X-axis to finish the setting automatically , if X, Y position not set, press direction key to adjust the position of the shaft manually. The corresponding relationship between arrow keys and the axis is: press left arrow key to increases the X-axis show value; press the right arrow key to decrease the X- axis show value; Press the upward direction key to reduce the Y-axis show value; Press the downward direction key to increase t